What is the basic concept of hydraulic motor? What kind of promotion? Basically, how is the basic principle of the work content actually operated?

The following details the basic concept of hydraulic motor

     Double output shaft cycloidal motor In application, the transmission shaft will not be driven by the transmission device any more, but only connected with the organization in work. Input the working pressure oil from the oil inlet hole. The working pressure oil enters the working chamber of the motor according to the flow channel after passing through the oil inlet hole, and causes the hydraulic machine interaction force that promotes the plunger pump above the plunger pump. Because the cam has the existence of eccentricity, the interaction force will produce a torque to the rotating management center of the cam, Make each cam and transmission shaft rotate clockwise; Because of the inertia force, the cam will turn to the geographical position and then rotate clockwise to shift the plunger pump, leaving the completed oil in the working chamber to, and the oil drain valve and outlet of the single project will discharge to the car tank;

Because the relative position of the two cams is suitable, the plate is allocated OM series cycloidal hydraulic motor Turn off the oil drain valve in case of liquid inlet, and turn off the other oil inlet valve in case of oil discharge to facilitate the completion of flow distribution. If Luanmusi inputs the working pressure oil from the oil inlet of the hydraulic motor, the motor can push the working organization connected with the drive shaft to complete the continuous clockwise rotation fitness exercise. In addition, the used oil is continuously transmitted from the oil drain valve.

The condition of the hydraulic motor is similar to that of the hydraulic oil pump. If the direction of the input oil is in the opposite direction, in other words, the area of the input oil is changed to the oil inlet and the oil inlet is drained, then the rotation direction of the transmission shaft or motor rotor must also be in the opposite direction, in other words, it should rotate in the opposite direction.