Hydraulic motor It has high efficiency in China's high pressure zone. Manufacturer of cycloidal hydraulic motor In addition to the service life and output power utilization rate of the motor when carrying out pressure equipment, the motor should be recruited near the high pressure as far as possible. The hydraulic motor has high efficiency at medium speed. Reduce the motor displacement, and the motor efficiency is reduced. Especially in the low speed area with small displacement, the efficiency is lower, and the professional ability is too weak. The motor can work efficiently only when the displacement is large. When carrying out displacement control on the hydraulic motor, its working condition should be that the motor is large displacement and low speed when the load is increased, and small displacement and high speed when the load is reduced. The minimum displacement ratio of the motor shall be less than 0.3 when the motor operates at low speed and small displacement. In the specific design process, the hydraulic motor and the pump have a matching relationship on the displacement. Generally, the displacement of the motor should be 1.2~1.6 times of the pump displacement, otherwise, Hydraulic cycloidal motor manufacturer's direct sales Common faults such as too high working pressure of system software, too large fluctuation of speed, too high speed of hydraulic motor, speed loss of automobile engine and poor working efficiency will occur. Generally speaking, the larger the displacement of the hydraulic motor is, the better. However, the larger the displacement of the hydraulic motor is, the higher the manufacturing cost will be.