Torque calculation method of low speed ratio, namely Hydraulic motor What is the practical significance of torque?

     Special cycloidal motor for hydraulic winch The manufacturer told you how to calculate the torque?

Outer Five Stars Hydraulic motor manufacturer The relevant internal curve diagram motor roller solves the problem of impact, vibration and noise caused by the vertical plane of the motor stator double warping plate, and the difficulty of damage caused by serious problems?

The working pressure of the motor cap and oil valve is required. Generally, the working pressure of the oil valve exceeds the working pressure of the cap, then the hydraulic plunger pump will stick to the motor stator ring for operation. If the working pressure of the cap exceeds the working pressure of the oil valve, then the hydraulic plunger pump will be pushed away from the motor stator ring, and all the oil inlet ports will be replaced with high pressure ports, High working pressure will bump the hydraulic plunger pump into the motor stator ring, causing a loud noise. A long time will cause many pits on the motor stator ring, which will not work if the motor is fast.

     Low speed high torque hydraulic motor How to rotate the wrong stator and rotor pair? The stator and rotor pair is due to the wrong relative position of the rotor and the port plate. The roller line hydraulic motor is divided into two types: shaft port and internal thread port.

The way to carry out flow distribution for the machine tool spindle bearing is to punch an oil groove on the bearing end cover of the rolling bearing to break through the minimum sealing cavity of the rotor stator pair. Try it. If there is a tooth leakage when turning it over, it is OK. Select the port plate to carry out internal thread flow distribution, connect the port shaft with the motor rotor, install the motor stator pair, and measure the deep layer of the airtight cavity. If the cavity in the clockwise direction with the least airtight cavity is higher than the cavity in the reverse direction, it will rotate.

The deep layer is the sum of stator, baffle and port plate. Its key reason lies in the valve plate. Generally speaking, when liquid is fed into the side of the port plate, the clockwise inner cavity (high pressure inner cavity) where the rotor stator is located just leads to the above minimum sealing inner cavity.