(1) On the premise that the main control circuit valve, load valve and other accessories are intact, block the oil inlet pipe and the motor socket (no oil leakage), and measure the larger working pressure of the oil passage provided when the motor is turning over and forward; Then connect the motor pipe to measure the working pressure under load; Finally, comparing the measured value with its technical standard, we can judge the location of common faults.

(2) Since the total flow of the hydraulic oil pump is insufficient or the working pressure is low, the motor power will decrease, and the torque and speed ratio will decrease at the same time, so the measurement of the total flow should be carried out smoothly with the measurement of the working pressure.

(3) Check whether the clearance between the port shaft and the rotor hole is within the allowable range (see the note), and whether the rotation axis of the port shaft and the engine cylinder block hole is consistent. If it exceeds the specified value, reassemble it. If the clearance between the port shaft and the rotor hole exceeds 0.6 mm, or the port hole in the rotor is grooved circumferentially; The clearance between plunger pump and rotor exceeds 0.05mm, and the clearance between roller square shaft and sliding rail exceeds 0.05mm Sample of cycloidal hydraulic motor Weak rotation. If the two walking motors have different steps, the crawler direction will deviate.

(4) The oblique disc radial piston pump motor, after long-term high-speed operation, will expand the clearance of the output shaft support rolling bearing, and the radial positioning clearance will exceed the compensation value of the large disc torsion spring; The engine cylinder (rotor) and port plate were checked, because the four butterfly springs on the positioning rod of the management center could not press the rotor cylinder to the port plate normally (the fatigue limit of the disc spring was reduced, when the elasticity was reduced, the motor could operate normally in the hot state, and the deformation of the disc spring would increase in the hot state), which reduced the working capacity of the port plate and led to the motor's weak operation. When the clearance between rotor and cylinder hole exceeds 0.05mm, or the damage exceeds the standard value Positive and reverse cycloidal hydraulic motor Weak and sluggish.

Above is how to clear Hydraulic cycloidal slewing motor There are four ways to solve the problem of weak rotation.