Avoid High torque cycloidal hydraulic motor Countermeasures for oil leakage:

1. Through analysis and calculation, it is known that the oil leakage is caused by the extremely high working pressure of oil leakage in the motor housing, so the overall goal of all leakage repair measures should be to relieve the pressure. In fact, there is such a way.

2. Reasonably arrange the drain pipe: many hydraulic press professional technicians do not attach great importance to the allocation of the drain pipe, and think that it is only necessary to return to the car oil tank immediately, and the pipe diameter size does not care. From the pressure loss resistance measurement formula, it can be seen that the resistance size is inversely proportional to the 5th power of the pipe diameter. Under the same other standards, only need to change the diameter of the drain pipe to 10, then the along way resistance: Pf=0.15MPa. Under this condition, the oil discharge working pressure can be completely reached.

3. In addition, pay attention to Cycloidal hydraulic motor of mixer The harm of pipe length is linear correlation between pipe length and pressure loss resistance. Under the same standard, if the pipe length is doubled, the resistance will also increase. Therefore, attention should be paid when the oil drain pipeline is long.

4. Effectively determine the total flow of flushing oil. Since the total flow of flushing oil is too small to achieve the actual effect of temperature reduction, the oil drainage resistance will be expanded when flushing is very large.

5. The proper total flushing flow can refer to the technical documents of relevant manufacturers, and can also be measured and determined according to the thermal cycle standard.