Network optimization information:

Start up and run.

1、 Start preparing.

Before starting, check whether the installation and connection of the motor are correct and firm, and whether the system is correct. And inject filtered hydraulic oil into the housing from the engine outlet.

B Check whether the rotation direction of the motor in the oil outlet direction is consistent with the factory requirements.

The pressure of the overflow valve of the oil supply pipe shall be adjusted to the minimum, and gradually adjusted to the required pressure after operation.

2、 Operation, use.

The starting shall be carried out under no load condition, and gradually accelerate to the working state, Traveling cycloid motor No load operation shall not be less than 20 minutes, then gradually pressurize to the working pressure, operate for 1-2 hours, and observe whether the motor operates normally. During operation, the working condition of the motor and system shall be checked frequently. If abnormal temperature rise, water leakage, vibration, noise or pressure fluctuation is found, the work shall be stopped immediately, and the causes shall be found out for timely maintenance.

Check the liquid level of the oil tank frequently. If there are a lot of bubbles, stop the machine in time to check.

Regularly check the quality index of hydraulic oil. If it is found that the quality index exceeds the specified quality index, replace it with a new hydraulic oil. Cycloidal hydraulic motor travel The type and amount of oil and mixture shall not be changed at will, otherwise the use performance of the motor will be affected. The period for replacing new oil depends on the working condition, and the user can specify it according to the actual situation.

Check the use of the oil filter frequently, and clean or replace it regularly.