Network optimization information:

rotate Hydraulic motor Disassembly and assembly of components.

Use an Allen wrench to take out the hexagon countersunk bolt, take out the hydraulic motor, and remove the oil seal cover from the bottom cover. If Low speed hydraulic motor Screw the bolt into the threaded hole on the hinge, just remove the oil seal cover.

Remove the oil seal from the oil seal sleeve. Note: If there is no damage, do not remove the oil seal. Do not continue to use the oil seal after removing it from the oil seal cover.

Remove the bottom cover after removing the hexagon countersunk head bolts and bolts. Note: After the hexagon countersunk head bolt and bolt are removed, the bottom cover will be automatically pushed into the middle position.

Take out the C-ring and take out the needle bearing from the bottom cover.

Pull out the barrel and barrel. Note: When taking out the plunger barrel from the housing, be careful to prevent the plunger from falling off from the hydraulic cylinder barrel. If the plunger of the hydraulic cylinder falls off Agricultural hydraulic motor The plunger should be replaced in its original position. The configuration position of each plunger in the hydraulic cylinder remains unchanged, and the installation sequence and position must be marked and recorded.

Take out the C-shaped circlip, knock out the shaft and oil seal cover from the housing with a plastic hammer, and pull out the ball bearing.

When disassembling the bearing, pay attention to that the external force should be applied to the inner race, and that the sealing surface such as the housing should not be damaged when taking out the C-shaped spring.