Talking about Hydraulic motor In fact, the problem of getting hot is a wide range of problems in daily work, but it is also a headache, especially in the hot summer, there are some working conditions that work for a long time and load operation, which are likely to cause a lot of problems, and it is also likely to be more serious. In terms of work, the hydraulic motor and hydraulic pump are the two most important ironing agents in the electric hydraulic pump. As an electric actuator, the hydraulic motor is an important part of the whole process of promoting rotary exercise fitness and transforming pressure energy into mechanical energy of mechanical equipment. Today, Ningbo Nishi Sizhu Hydraulic Press Innovation Technology Co., Ltd. will give you an important analysis of the reason why the hydraulic motor is hot, and clearly point out the specific solutions, hoping to help you.

It is inevitable that the hydraulic motor burns in all electric hydraulic pumps, but the Standing Committee of Japan must strictly control the burning condition, and Cycloidal motor with reducer Keep abreast of the hot condition of the hydraulic motor. In short, "burning" is the loss of mechanical energy, that is, a lot of power is busy, which immediately becomes the calorific value. That is to say, under the same working condition and geographical environment, if the hydraulic motor is more hot, it means that the hydraulic motor has worse characteristics and general mechanical kinetic energy is slightly lower. Therefore, under the condition of the hydraulic motor in the scheme design, it is necessary to ensure that the negative pressure balance and the friction of industrial equipment are as small as possible Small hydraulic cycloidal motor The mechanical kinetic energy can be improved as much as possible to prevent the hydraulic motor from becoming more and more hot. However, it must be noted that the hydraulic motor is hot or unavoidable in the whole process of operation.