Planetary reducer The hydraulic motor is a small and medium-sized low-speed high torque hydraulic motor with one shaft flow distribution and toothed fixed motor rotor pair. The positive and reverse cycloidal hydraulic motor is small in size and light in weight, and its size is far smaller than other types of hydraulic motors with the same torque.

Planets Reducer The hydraulic motor is a small and medium-sized low-speed high torque hydraulic motor with one shaft flow distribution and toothed stator motor rotor pair. It is small in size, light in weight, and far smaller than other types of hydraulic motors with the same torque. The speed ratio covers a wide range, allowing stepless speed change. The low flat and stable speed ratio can reach 15 rpm. The installation layout is convenient, and the project investment cost is low. It can be used in series in hydraulic transmission system. The rotating inertia force is small, and it is very easy to start under load. The cycloidal hydraulic motor with plate flow distribution can be used in both forward and reverse rotation, and there is no need to shut down during phase change.

    1、 Cycloid hydraulic motor If the oil level in the hydraulic oil filter element of is too low, it will be informed that the returned gear oil will appear on the surface of the car oil tank and cause many bubbles. In addition, if there is steam leakage at the inlet of the oil inlet pipe and the hydraulic oil pump, there will also be a lot of gas entering the hydraulic engine cycle and thus bubbles will appear.

    2、 Hydraulic motor of cone crusher During the transportation and filling of gear oil, a small amount of gas will float in the oil with spherical bubbles of small diameter. The gas and gear oil melt and invade each other, and the chemical properties of the gear oil remain unchanged. However, when the gear oil melts a total amount of gas and is in a saturated state, when it flows through the channel of the speed control valve or pump, a part of the saturated gas dissolved in the gear oil will be separated and gradually gathered due to the sudden decrease of the working pressure, Cause very large bubbles.

3. There will be some small amount of gas in the gear oil of the cycloidal hydraulic motor. If the production of gear oil is carried out under superheated steam, a small amount of gas will be brought in the whole process of gear oil, which will also cause bubbles.