How to improve Cycloid hydraulic motor Speed of, High torque hydraulic motor Of course, increasing the total flow can increase the speed, but more or less it will endanger the service life of the cycloidal hydraulic motor. But as long as it is within its maximum power range, there is no problem. If the steam pressure reaches the rated working pressure, increasing the speed will exceed the range of output power that it can bear, which will naturally harm the service life of the cycloidal hydraulic motor.

     Hydraulic motor of snow sweeper There is only a limited increase in the total flow rate. If the speed is increased from 500 to 900, it is proposed to replace the motor with a new model and specification. If the total flow rate of the cycloidal hydraulic motor is increased to a certain level, the speed is not easy to rise indefinitely. The internal steam pressure rises, and internal leakage expands, resulting in an immediate decrease in efficiency or motor damage.

How can the rotor pair of the cycloidal hydraulic motor and the misaligned motor turn over? The stator motor rotor is correct. It is the relative position of the motor rotor and the port plate is incorrect. The cycloidal motor is divided into two types: shaft flow distribution and inner hole flow distribution. The method of shaft flow distribution On the main shaft bearing, you can make a mark on the bearing end cover against an oil groove, and against the minimum sealing cavity of the rotor stator pair. Try it. If you want to turn it over, it would be better to make another tooth wrong. The method of inner hole flow distribution is the port plate. According to the connection between the port shaft and the rotor, after the motor stator pair is installed and rotated, it is OK to accurately measure the deep layer of the sealing cavity. If the clockwise cavity of the least sealing cavity is deeper than the cavity in the opposite direction, it is a positive rotation, and the reverse is a reversal.

     BMP cycloidal hydraulic motor The deep layer is the sum of rotor stator, baffle plate and port plate. The key reason lies in the valve plate. Generally speaking, when the side of the port plate is filled with liquid, the cavity (high pressure cavity) that just goes to the clockwise side of the least sealing cavity of the rotor stator is the forward rotation.

The above article is my interpretation of the relevant professional knowledge on how to improve the speed of the cycloidal hydraulic motor. I firmly believe that you will have some help after reading it. If you want to consult a lot of relevant news about cycloidal hydraulic motor, you can pay attention to our official website.