Vertical hydraulic wire rolling machine is widely used in industrial production, because plastic deformation production and processing method is selected. Compared with drilling production and processing with iron pins, the compressive strength of each layer of the product workpiece is good. What is the component of the wire rolling machine? The main body, driving force distribution box Hydraulic transmission The system, extrusion molding system software, exchange reduction gearbox, refrigeration system and circuit system are composed.

Know the components of the vertical hydraulic thread rolling machine, then how does the hydraulic transmission system work? So, Star wheel hydraulic motor What is the principle of oil? Let's have a look.

1. Turn on the switch power supply of the thread rubbing machine, turn on the cooling circulating water valve, press and hold the forward running button, then turn the feed handle, feed along the product workpiece orientation, and complete the laser cutting. When the length of the rib disengagement is specified, the rib disengagement knife will automatically open. Rolling the external thread can be completed by rolling the handle and feeding again. When the roller touches the building reinforcement, it must be forced to roll, and the main shaft bearing rotates for one circle. Radial feed is the pitch diameter. When the feeding reaches a certain level, the automatic feeding can be completed until the whole cold rolling process is carried out, and the automatic termination is implemented by pressing and holding the reverse direction start button.

2. When the thread rolling machine automatically retracts, rotate the feed handle clockwise to make the rolling head return to the original position. At this time, the disengaged rib is automatically calibrated. Remove the finished product workpiece.

3. Use ring gauge to check the length of external thread of the thread rolling machine, and the deviation is within this range. In addition, check the thread size with external thread according to the caliper gauge. Generally, the instrument panel can be screwed in. The anti projectile motion meter cannot be screwed in or completely screwed in.

4. When the wire rolling machine rolls the reverse direction line, first exchange the two parts of the roller in the rolling head; Then exchange the position of the limit switch before and after the block, and ensure that the travel arrangement will not change.

Switch on and off the power supply of the vertical hydraulic thread rolling machine, open the cooling circulating water valve, press and hold the forward running button, and the feed handle can be rotated to feed the product in the direction of the workpiece to complete the laser cutting. When the length of the rib disengagement is specified, the rib disengagement knife will automatically open. Rolling the external thread can be completed by turning the handle to feed again. When the roller touches the lifting rod, the force must be increased and the main shaft bearing must rotate for one circle. Radial feed is the pitch diameter. When the feeding reaches a certain level, the automatic feeding can be completed until the whole cold rolling process is carried out, and the automatic termination is implemented by pressing and holding the reverse direction start button. When the thread rolling machine automatically retracts, the feed handle rotates clockwise to make the rolling head return to the original position, and the thread cutter is automatically calibrated. Remove the finished product workpiece.