When the inertia force of the driven device is large, if it is required to brake, reverse and follow the vehicle in a short time, in order not to damage the safety accident due to the impact of the hydraulic press, a valve buffer must be set in the oil return passage.

2. When using quantitative analysis motor, if you want to start 530 cycloidal hydraulic motor And parking stability, you should select the necessary working pressure control or flow monitoring mode when designing the control circuit.

    3、 Hydraulic motor When being used as the driving force of special lifting tools or walking equipment, be sure to set the speed limit valve to avoid speeding when the lifting object drops quickly or the lifting mechanism such as the car goes downhill, which may lead to serious safety accidents.

4. Because there is always leakage in the hydraulic motor, the inlet and outlet of the hydraulic motor will be closed for braking, and it will still move slowly. When long-term braking is required, the brake to avoid rotation should be set again.

5. When it is necessary to start with full load, attention should be paid to the starting torque of the hydraulic motor. Since the starting torque of the hydraulic motor is smaller than the rated torque, the organization may not be able to operate if it is ignored.

6. Because the pump oil back pressure type (outlet working pressure) of the hydraulic motor is higher than the atmospheric pressure, the discharge oil pipes of the motor need to be independently led back to the car oil tank, and cannot be connected with the return oil pipe of the hydraulic motor.