Danfoss Hydraulic motor It is a machine that converts the four column hydraulic function into mechanical energy of mechanical equipment. The hydraulic motor valve can carry out continuous rotation exercise for fitness. Its structure is similar to that of the hydraulic pump, and it also works by changing the airtight volume.

Extensive Cycloidal motor rotor There are several important methods of transmission system transmission gear type, vane type and gear pump type; In terms of transmission ratio and torque range, there are high speed motors and low speed high torque motors.

The basic principle of the motor and the pump is reciprocal. When pressure oil is input into the pump, the output transmission ratio and torque of the shaft become the motor. However, because their daily tasks and requirements are different, only a few pumps can be used as motors in practice.

In addition, during the installation of the hydraulic motor brake valve, it is forbidden to hit it with a hammer to prevent the axial force or excessive axial force from damaging the roller bearing or the transmission gear of the transmission system. Be sure to tighten the installation anchor bolts before tightening the anchor bolts. Before installation Oil motor Use gasoline or zinc sodium water to clean the antirust oil of the input shaft, accurate positioning die seat and reducer connection parts. Its purpose is to ensure the close connection of the connection and the coordination of the operation, and to prevent unnecessary destruction. Before the oil motor is connected with the reducer, please make the oil motor shaft key groove perpendicular to the torque anchor bolt. In order to ensure uniform support, first screw on the installation anchor bolts at any included angle, but do not tighten them. Then screw on the installation anchor bolts at other two included angle positions, and finally tighten the four installation anchor bolts one by one. Finally, screw the anchor bolt of the dead force. All torque anchor bolts shall be fixed and checked with a torque wrench according to the indicated fixed constant torque data information. The relevant data information of the tilt angle reducer is not completely consistent with that of the same linear reducer. Please pay attention to it. Proper installation between reducer and mechanical equipment is similar to that between reducer and controller oil motor. The key is to ensure that the output shaft of the reducer is consistent with the parallelism of some shafts of the controller.