The product categories of White supplied are: WHITE Oil motor , WHITE hydraulic pump, WHITE brake, manual release pump, hydraulic plunger pump, WHITE flow regulator, Reducer And rotary drive. Its product categories: WP, WR, WG, HB, WS, CE, RE, DR, DT, D9, HB, HK, CE, DR, DT, BK, SB, etc.
WHITE in the United States White motor Detailed description: 1. Vane motor
At the same output power, the vane motor has smaller volume, lighter net weight and lower price than the piston motor. In view of the simple design concept and production, it can be used in almost any category. Vane motor can work in a wide range of speed ratio and torque. It is a common type of pneumatic motor.
2. Radial (radial) piston motor
Its speed ratio is smaller than that of vane motor, but it has very good starting and speed ratio control characteristics, especially when it is suitable for radial heavy load and low speed gear. Piston motors are usually used horizontally.
3. Reversible/irreversible motor
In the same type, the speed ratio, torque and output power of the irreversible air motor are greater than those of the reversible air motor.
4. Working pressure
When selecting the air motor, the characteristic table shows that the air can reach one group of performance indicators under the specified working pressure of 90 psig (620Kpa), and the air motor is in an excellent design operation state under this working pressure. After adjusting the inlet and exhaust pressure, the speed ratio, torque and output power of the throttle motor can be adjusted infinitely;
When the working pressure of the air motor is less than 40 psig, its characteristics may be unstable;
The air motor can work under the working pressure of more than 100 psig, but the damage of the air motor is aggravated at this time;
In clarifying Hydraulic motor A basic principle can be followed in model selection: 70% of the minimum pressure available is taken as the base for selection. This allowable air motor has sufficient driving force to deal with starting impact and possible load.
5. High power of air motor
The high power of the non speed limiting air motor is realized when the speed ratio is 50% of the random speed ratio (no-load speed ratio);
The high power of speed limiting air motors (22 and 55 categories) is achieved at 80% of the random speed ratio (no-load speed ratio).
6. Speed ratio during operation
The speed limiting air motor will not run without load;
The working speed ratio of the air motor can be verified in its characteristic curve, and the nominal speed ratio on the nameplate is only for difference.
7. Working torque
In clarifying Radial plunger motor For the model, the torque in operation is as important as the speed ratio, and these two parameters determine the output power of the air motor. When selecting, pay attention to the difference between the static large torque and the working torque.
8. Speed ratio and torque
The starting torque is about 75% of the maximum torque;
The working torque (at different speed ratios) can be verified on the motor characteristic curve or calculated by the following formula:;
Torque (pounds, pounds)=horsepower. 5250/speed ratio (r/min)
Torque (N. M)=KW.9550/speed ratio (r/min)
9. Radial load of air motor output shaft
When selecting the air motor, the radial load of the output shaft of the air motor should be taken into account (define the point at which it acts on the shaft key). See the motor characteristic curve.
